Automatic Hand Sanitizer Dispenser

Automatic Hand Sanitizer Dispenser

Introduction

Automatic Hand Sanitizer Dispenser has an intelligent inductive sanitizer dispenser with digital circuit control, infrared automatic induction, and battery(or DC power supply)drive. Reliable operation, the strong anti-interference ability of light source, sensitive induction, etc. 

Advantages

• Infrared induction automatic spraying liquid, suitable for all type of disinfectants
• Use of liquid medicine/hand sanitizer; design to drive circuit with low energy consumption and battery life
• Long life is the ideal choice for public places
  

Features 

• Fully automatic induction-to avoid the spread of bacteria caused by contact.
• Fully automatic power-saving chip-more energy-saving, environmentally friendly, and cost-effective.
• More user-friendly design simple installation, simple use, and long life.
• Long battery life and supports AC/DC power supply.
• Automatic continuous spray function, when continuous sensing, the machine will spray one every 3 seconds; It will automatically stop, re-sensing, you can continue work.
• 100% touchless system
• Large capacity for use of various disinfectant liquid and hand sanitizer (Smart Spray wine)
• Runs on a rechargeable battery or USB cable to Light. (Dual power supply)
• Suitable for public places such as office hotel hospital medical institutions and school.
• No need for punching holes.

PRECAUTIONS

1. When adding liquid, the power supply should be disconnected, and the machine can not work. Close the front shell, and the green light shows that it can be used.
2. In order to prevent misoperation, there should be at least 40cm space under the machine and do not install in places exposed to strong sunlight and above strong reflective objects.
3. Prevent any objects from blocking the liquid outlet.4. Keep the liquid in the machine clean ad-free of other strip-shaped or block-shaped impurities.5. Avoid direct fire on the machine.6. If there is liquid in the container during disassembly, it is forbidden to lay the product flat to prevent the liquid from flowing out. Wetting the motor and circuit board, causing damage, the liquid must be poured out before it can be laid flat.
4.  This product is not waterproof. Do not touch or splash the circuit part and keep away from high temperature such as fire source
5. Power supply mode: USB power supply/four AA batteries.
6. The input voltage of this product is 5V DC. Do not use the charging adapter with a higher voltage.
7. Charging prompts if the red light exceeds 4 hours, please stop charging immediately to prevent excessive battery charging and accidents. Batteries or charging wires should be replaced or confirmed by maintenance personnel.
8. The pack contain important information and must be retained